Nail up the large base photo 13.
Installing trim around sliding glass door.
Nail the cap and shoe.
Use a putty knife to remove the excess.
In either case once you re ready to begin choose a side of the door to begin with and start lining the molding up in the exact spots you measured and marked earlier.
Threshold molding can be reused on sliding gl.
Make use of various t molds that are available for your laminate here.
Cut all the base extra long rough cut all the baseboards about 2 in.
Replacing sliding glass doors.
Trim with a 1 8 inch gap after the flooring has been laid.
If this is the case it is recommended to put the molding up around your sliding glass door piece by piece.
Step 3 install.
Secure the threshold to the door with screws.
Cover the foam insulation with trim and add a small amount of caulk to the visible joint.
Replacing sliding glass doors.
Make sure the screws aren t exposed.
Place a piece of threshold trim available at the flooring supplier next to patio doors or similar thresholds where you need to stop the laminate flooring.
Measure the lip of the threshold s trim and leave enough clearance between the door and the flooring to install the threshold.