The door must be no thicker than 1 3 4.
Installing sliding barn door hardware.
Measure and cut two lengths of mounting board for each barn door.
Use the stud finder to locate and mark the studs above the door.
Slide the bolt through the hole and mount the rolling hardware then drill the bottom hole.
The boards should be as long as the doors and about 1 inch or 4 cm wider than the track.
Place the strap on the face of the door with the wheel side facing towards the back.
Using a stud finder and a level hang the mounting board on the wall studs.
For single doors start about three or four inches up on the hinge side of the door opening and continue for the length of the backer board.
Installing the door hardware is easier so start there.
Attach the mounting boards to the top and bottom of the doorway using drywall anchors and ensure that the mounting boards run straight along the doorway.
The wheels have a groove in the middle for the rail to rest in.
The kit comes with a handy metal measuring tool you can insert in the groove to simulate the rail.
National hardware provides a mounting template you can use it to locate your holes for the rolling hardware.
Installing barn door hardware process.
I used 3 wood screws to attach it and made sure i place a screw on every stud.