Installing Roof Shingles And Flashing

This how to video explores proper roof flashing installation for shingle roofing applications.

Installing roof shingles and flashing.

How to apply roof ventilation on shingles roof. You will also need rake edge flashing for the sides of the roof. Secure the horizontal flange to the roof deck using two nails. Continuous flashing against a sidewall is one way to install a roof but it s not the correct way.

Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt. This movie shows you how to install step flashing on a roof with iko roof shingles. Using your staple gun secure the felt to the roof. Flashing is installed to surround roof features such as vents.

Nail metal flashing called drip edge along the bottom edge of the roof deck near the gutters. Then nail the new l shaped flashing under the builder s felt but above the fascia board. To install the flashing piece on the first course place it over the end of the starter strip. Install the step flashing when the siding is installed it should be tucked behind this piece and then consecutive courses lapped over it.

Install your underlayment completely and your shingles up to where the wall begins so that the first piece of flashing or the corner flashing will rest on a shingle. How to install roof flashing against a wall. Apply a flashing piece then a shingle then flashing as you would apply step flashing for a chimney. Place it so the tab of the end shingle covers it completely.

To make corner flashing take your tin snips and cut a 45 degree line from an outside corner to the center fold. Start by laying asphalt felt or other underlayment over the roof. The remaining siding on the sidewall will overlap the step flashing and nail. If the roof meets a wall that is parallel to the shingles roof up to the wall then slip a long continuous piece of flashing under the siding and on top of the shingles.

However when flashing crowne slate with its much larger 10 exposure the flashing piece would need to be 10 x 12. Step 18 shingle peaks and hips. Step flashing redirects the water back onto the shingle. Install new flashing metal.

Overlap each row at least 3 to 4 inches. Begin by removing the shingles at the affected area and removing old flashing if present.